PopGrabber Installation

To install PopGrabber run "PopGrabber_Setup.exe" and follow the instructions on screen.

PopGrabber is installed by default as a Windows service running under the Local System account. You can manually change this after installation if your server requires it (for example, because of a firewall configuration). The account under which the PopGrabber service runs must have the following permissions:

The PopGrabber service will start automatically at the end of the installation, you can also start it and stop it using the PopGrabber console.

Important!
Before you can use the PopGrabber service you need to fill up your registration information using the PopGrabber console. The service will not download any messages until the registration information is complete.